AurasGlow - Red Dragon Fire [Turns Milky after 1st Run]

On 1st run, the Goo stayed to the side in the middle and some floated to the top. Took the globe out and after few minutes, the globe turns milky. Hope this willl settle down and improve.

Views: 40

Comment

You need to be a member of WWW.OOZINGLAVA.COM | The Fantastic Forum for Lava Lamps to add comments!

Join WWW.OOZINGLAVA.COM | The Fantastic Forum for Lava Lamps

Comment by ElectricAstro on September 20, 2011 at 3:56pm
Don't worry Simon! It will clear up! Aurasglow lamps are really nice lamps!
Comment by Bohdan on September 20, 2011 at 12:28pm
A coil will bring in some more heat but the lava would now have a better flow going up and may even have a snake flow as it goes. With coil the candle will need to sit lower yes.
Comment by dumchidumchi on September 20, 2011 at 11:41am
Would the coil generate more heat...heat up faster?  I've already noticed that there might be an overheat problem.  It's my 1st day with it...so, it's still too early to say.
Comment by Bohdan on September 20, 2011 at 11:36am

I have always wondered if this lamp would run better if it had a small coil inside it. The coil would make the liquid lava flow better warm up faster and as it flowed better would run longer.

Comment by dumchidumchi on September 20, 2011 at 11:33am
Well, few collectors told me it's normal that it turns into this milky look.  Let it sit overnite and it will clear up.  I just don't know...it's my first day with it...need more time to try it out.
Comment by Bohdan on September 20, 2011 at 10:50am
This one looks bad and if it does not clear up within 2 weeks then a replacement should be given. Once the lamp becomes very hot the sticky lava on the globe should flow off.

© 2025   Created by ElectricAstro.   Powered by

Badges  |  Report an Issue  |  Terms of Service